HQIP (Hardware Quick Inspection Package) is a hardware diagnostic firmware image that detects hardware problems on Fortinet products including FortiGate, FortiWifi, FortiAnalyzer, and FortiManager. Running an HQIP test has information about wiring your device, console connection, hardware, tftp server, and connecting to the device.Pre-Requisite:-Console access is recommendedSelect tests require the use of loop-back cablesRe-cabling of your current Read more about How to do Hardware troubleshooting with built-in hardware diagnostic commands in fortigate device[…]
The hostname of a device is its identification. A router or switch must have its identity established to be accessible on the network to other devices. The name value must be less than 256 characters. To set the hostname using a configuration :- root# set system host-name Router-1 root# commit Router-1 #
If you want to configure on a router or a switch is the hostname. The default name for routers is Router and the default name for switches is Switch. To configure the hostname for the switch, use the hostname command:- Router>enableRouter# configure terminalRouter(config)# hostname TESTTEST(config)# endTEST(config)# copy running-config startup-config
To change the password for the wireless network on your Shaw wireless modem, you will need to log into the admin console which will allow you to configure various settings related to your wireless network. Before proceeding, ensure that you have an ethernet cable connecting your modem to your computer/laptop. Process to Change the Password Read more about How to change your WiFi password on a New Cisco Modem[…]
Virtual Chassis is a feature in Ethernet Switches that allows you to interconnect two or more switches, enabling them to operate as a unified, single, high-bandwidth switch. It provides network resiliency in the form of redundant Routing Engines and network expansion flexibility with minimal impact to a configuration. \ EX 2300 Virtual Chassis Configuration All EX-2300 Read more about How to configure Virtual Chassis in EX-2300 Juniper[…]
To display the hostname and version information about the software running on the router or switch.
To display the configuration of the system hardware, the software version, the names and sources of configuration files, and the boot images, use the show version EXEC command. Router# show version
Juniper MX Series Introduction Knowledge Base << Juniper MX-Series : Knowledge Base >> How to disable the alarm of Ethernet link down in Juniper MX-Series Router Management interfaces are the primary interfaces for accessing the device remotely. Typically, a management interface is not connected to the in-band network, but is connected instead to the Read more about How to disable the alarm of Ethernet Link Down in Juniper[…]