Aruba Wireless
  Knowledge Base

<< >>
How to get the output of CLI Command without break/paging in Aruba Controller


This article will provide  to display the output of CLI command without break/paging in Aruba Controller

Configuration Steps:-

     To get the output without break/paging of CLI Command in Aruba Controller , Follow the below steps :-

 1) Login the switch

login: username

 2) Once you will login the Controller, Go to Enable mode with command "enable"

(Aruba Controller) >enable


 3) Go to enable mode from operational mode

(Aruba Controller)#

 4) Use the  " no paging" command

(Aruba Controller) # no paging

5) Then after enter the CLI Command to display . It will not break/pagination the output of command. As example you can use the command

(Aruba Controller) #show running-config

<< >>